| 1 | /* SPDX-License-Identifier: GPL-2.0-or-later */ |
| 2 | /* |
| 3 | * bq2415x charger driver |
| 4 | * |
| 5 | * Copyright (C) 2011-2013 Pali Rohár <pali@kernel.org> |
| 6 | */ |
| 7 | |
| 8 | #ifndef BQ2415X_CHARGER_H |
| 9 | #define BQ2415X_CHARGER_H |
| 10 | |
| 11 | /* |
| 12 | * This is platform data for bq2415x chip. It contains default board |
| 13 | * voltages and currents which can be also later configured via sysfs. If |
| 14 | * value is -1 then default chip value (specified in datasheet) will be |
| 15 | * used. |
| 16 | * |
| 17 | * Value resistor_sense is needed for configuring charge and |
| 18 | * termination current. If it is less or equal to zero, configuring charge |
| 19 | * and termination current will not be possible. |
| 20 | * |
| 21 | * For automode support is needed to provide name of power supply device |
| 22 | * in value notify_device. Device driver must immediately report property |
| 23 | * POWER_SUPPLY_PROP_CURRENT_MAX when current changed. |
| 24 | */ |
| 25 | |
| 26 | /* Supported modes with maximal current limit */ |
| 27 | enum bq2415x_mode { |
| 28 | BQ2415X_MODE_OFF, /* offline mode (charger disabled) */ |
| 29 | BQ2415X_MODE_NONE, /* unknown charger (100mA) */ |
| 30 | BQ2415X_MODE_HOST_CHARGER, /* usb host/hub charger (500mA) */ |
| 31 | BQ2415X_MODE_DEDICATED_CHARGER, /* dedicated charger (unlimited) */ |
| 32 | BQ2415X_MODE_BOOST, /* boost mode (charging disabled) */ |
| 33 | }; |
| 34 | |
| 35 | struct bq2415x_platform_data { |
| 36 | int current_limit; /* mA */ |
| 37 | int weak_battery_voltage; /* mV */ |
| 38 | int battery_regulation_voltage; /* mV */ |
| 39 | int charge_current; /* mA */ |
| 40 | int termination_current; /* mA */ |
| 41 | int resistor_sense; /* m ohm */ |
| 42 | const char *notify_device; /* name */ |
| 43 | }; |
| 44 | |
| 45 | #endif |
| 46 | |