| 1 | // SPDX-License-Identifier: GPL-2.0-only |
| 2 | // Copyright 2021 Jonathan Neuschäfer |
| 3 | |
| 4 | #include <linux/irqchip.h> |
| 5 | #include <linux/of_address.h> |
| 6 | #include <linux/of_irq.h> |
| 7 | #include <linux/printk.h> |
| 8 | |
| 9 | #include <asm/exception.h> |
| 10 | |
| 11 | #define AIC_SCR(x) ((x)*4) /* Source control registers */ |
| 12 | #define AIC_GEN 0x84 /* Interrupt group enable control register */ |
| 13 | #define AIC_GRSR 0x88 /* Interrupt group raw status register */ |
| 14 | #define AIC_IRSR 0x100 /* Interrupt raw status register */ |
| 15 | #define AIC_IASR 0x104 /* Interrupt active status register */ |
| 16 | #define AIC_ISR 0x108 /* Interrupt status register */ |
| 17 | #define AIC_IPER 0x10c /* Interrupt priority encoding register */ |
| 18 | #define AIC_ISNR 0x110 /* Interrupt source number register */ |
| 19 | #define AIC_IMR 0x114 /* Interrupt mask register */ |
| 20 | #define AIC_OISR 0x118 /* Output interrupt status register */ |
| 21 | #define AIC_MECR 0x120 /* Mask enable command register */ |
| 22 | #define AIC_MDCR 0x124 /* Mask disable command register */ |
| 23 | #define AIC_SSCR 0x128 /* Source set command register */ |
| 24 | #define AIC_SCCR 0x12c /* Source clear command register */ |
| 25 | #define AIC_EOSCR 0x130 /* End of service command register */ |
| 26 | |
| 27 | #define AIC_SCR_SRCTYPE_LOW_LEVEL (0 << 6) |
| 28 | #define AIC_SCR_SRCTYPE_HIGH_LEVEL (1 << 6) |
| 29 | #define AIC_SCR_SRCTYPE_NEG_EDGE (2 << 6) |
| 30 | #define AIC_SCR_SRCTYPE_POS_EDGE (3 << 6) |
| 31 | #define AIC_SCR_PRIORITY(x) (x) |
| 32 | #define AIC_SCR_PRIORITY_MASK 0x7 |
| 33 | |
| 34 | #define AIC_NUM_IRQS 32 |
| 35 | |
| 36 | struct wpcm450_aic { |
| 37 | void __iomem *regs; |
| 38 | struct irq_domain *domain; |
| 39 | }; |
| 40 | |
| 41 | static struct wpcm450_aic *aic; |
| 42 | |
| 43 | static void wpcm450_aic_init_hw(void) |
| 44 | { |
| 45 | int i; |
| 46 | |
| 47 | /* Disable (mask) all interrupts */ |
| 48 | writel(val: 0xffffffff, addr: aic->regs + AIC_MDCR); |
| 49 | |
| 50 | /* |
| 51 | * Make sure the interrupt controller is ready to serve new interrupts. |
| 52 | * Reading from IPER indicates that the nIRQ signal may be deasserted, |
| 53 | * and writing to EOSCR indicates that interrupt handling has finished. |
| 54 | */ |
| 55 | readl(addr: aic->regs + AIC_IPER); |
| 56 | writel(val: 0, addr: aic->regs + AIC_EOSCR); |
| 57 | |
| 58 | /* Initialize trigger mode and priority of each interrupt source */ |
| 59 | for (i = 0; i < AIC_NUM_IRQS; i++) |
| 60 | writel(AIC_SCR_SRCTYPE_HIGH_LEVEL | AIC_SCR_PRIORITY(7), |
| 61 | addr: aic->regs + AIC_SCR(i)); |
| 62 | } |
| 63 | |
| 64 | static void __exception_irq_entry wpcm450_aic_handle_irq(struct pt_regs *regs) |
| 65 | { |
| 66 | int hwirq; |
| 67 | |
| 68 | /* Determine the interrupt source */ |
| 69 | /* Read IPER to signal that nIRQ can be de-asserted */ |
| 70 | hwirq = readl(aic->regs + AIC_IPER) / 4; |
| 71 | |
| 72 | generic_handle_domain_irq(aic->domain, hwirq); |
| 73 | } |
| 74 | |
| 75 | static void wpcm450_aic_eoi(struct irq_data *d) |
| 76 | { |
| 77 | /* Signal end-of-service */ |
| 78 | writel(val: 0, addr: aic->regs + AIC_EOSCR); |
| 79 | } |
| 80 | |
| 81 | static void wpcm450_aic_mask(struct irq_data *d) |
| 82 | { |
| 83 | unsigned int mask = BIT(d->hwirq); |
| 84 | |
| 85 | /* Disable (mask) the interrupt */ |
| 86 | writel(val: mask, addr: aic->regs + AIC_MDCR); |
| 87 | } |
| 88 | |
| 89 | static void wpcm450_aic_unmask(struct irq_data *d) |
| 90 | { |
| 91 | unsigned int mask = BIT(d->hwirq); |
| 92 | |
| 93 | /* Enable (unmask) the interrupt */ |
| 94 | writel(val: mask, addr: aic->regs + AIC_MECR); |
| 95 | } |
| 96 | |
| 97 | static int wpcm450_aic_set_type(struct irq_data *d, unsigned int flow_type) |
| 98 | { |
| 99 | /* |
| 100 | * The hardware supports high/low level, as well as rising/falling edge |
| 101 | * modes, and the DT binding accommodates for that, but as long as |
| 102 | * other modes than high level mode are not used and can't be tested, |
| 103 | * they are rejected in this driver. |
| 104 | */ |
| 105 | if ((flow_type & IRQ_TYPE_SENSE_MASK) != IRQ_TYPE_LEVEL_HIGH) |
| 106 | return -EINVAL; |
| 107 | |
| 108 | return 0; |
| 109 | } |
| 110 | |
| 111 | static struct irq_chip wpcm450_aic_chip = { |
| 112 | .name = "wpcm450-aic" , |
| 113 | .irq_eoi = wpcm450_aic_eoi, |
| 114 | .irq_mask = wpcm450_aic_mask, |
| 115 | .irq_unmask = wpcm450_aic_unmask, |
| 116 | .irq_set_type = wpcm450_aic_set_type, |
| 117 | }; |
| 118 | |
| 119 | static int wpcm450_aic_map(struct irq_domain *d, unsigned int irq, irq_hw_number_t hwirq) |
| 120 | { |
| 121 | if (hwirq >= AIC_NUM_IRQS) |
| 122 | return -EPERM; |
| 123 | |
| 124 | irq_set_chip_and_handler(irq, chip: &wpcm450_aic_chip, handle: handle_fasteoi_irq); |
| 125 | irq_set_chip_data(irq, data: aic); |
| 126 | irq_set_probe(irq); |
| 127 | |
| 128 | return 0; |
| 129 | } |
| 130 | |
| 131 | static const struct irq_domain_ops wpcm450_aic_ops = { |
| 132 | .map = wpcm450_aic_map, |
| 133 | .xlate = irq_domain_xlate_twocell, |
| 134 | }; |
| 135 | |
| 136 | static int __init wpcm450_aic_of_init(struct device_node *node, |
| 137 | struct device_node *parent) |
| 138 | { |
| 139 | if (parent) |
| 140 | return -EINVAL; |
| 141 | |
| 142 | aic = kzalloc(sizeof(*aic), GFP_KERNEL); |
| 143 | if (!aic) |
| 144 | return -ENOMEM; |
| 145 | |
| 146 | aic->regs = of_iomap(node, index: 0); |
| 147 | if (!aic->regs) { |
| 148 | pr_err("Failed to map WPCM450 AIC registers\n" ); |
| 149 | kfree(objp: aic); |
| 150 | return -ENOMEM; |
| 151 | } |
| 152 | |
| 153 | wpcm450_aic_init_hw(); |
| 154 | |
| 155 | set_handle_irq(wpcm450_aic_handle_irq); |
| 156 | |
| 157 | aic->domain = irq_domain_create_linear(of_fwnode_handle(node), AIC_NUM_IRQS, ops: &wpcm450_aic_ops, host_data: aic); |
| 158 | |
| 159 | return 0; |
| 160 | } |
| 161 | |
| 162 | IRQCHIP_DECLARE(wpcm450_aic, "nuvoton,wpcm450-aic" , wpcm450_aic_of_init); |
| 163 | |